Custom Manufacturing
Five stages from spec to recurring production, each closed by a deliverable you can hold — a quotation, an approval drawing, a sample inspection report. The design, the tooling and the pass/fail decision stay with MotorBank at every stage.
Five stages, each with a deliverable
Send your spec
A drawing, a STEP file, a photo — or just the application.
Engineering review
A motion engineer reviews every inquiry and proposes the motor.
Quotation
Price, MOQ and lead time, with an approval drawing that defines exactly what will be built.
Sample
Prototype built to the approval drawing, with a sample inspection report for your validation.
Mass production
Repeat orders by your MB model number. Same spec, every lot.
You don't need a finished drawing. Tell us the application — load, speed, duty cycle, space — and our engineers propose the motor.
What can be customized
| BLDC / DC motors | Voltage (12–310V), power (10W–2kW), speed–torque curve, shaft (D-cut/keyway/hollow), flange, winding, connector/leads, encoder, brake, IP rating |
|---|---|
| Geared motors | Gear type (spur/planetary/worm/bevel), ratio, backlash grade (low-backlash helical available), self-locking, output geometry, hollow shaft |
| Stepper motors | NEMA14–42 frame, 2-/5-phase, custom winding (current/voltage), step angle, encoder, geared, hollow-shaft rotary table |
| Servo / actuators | 24V–380V, 50W–7.5kW, integrated wheel modules, jacking modules, frameless torque motors, brake, EtherCAT/CANopen |
| Gear reducers | Frame size, ratio 3–100:1, inline/right-angle, input interface (NEMA/custom flange), low-backlash |
| Linear actuators | Stroke, lead/speed, load rating, screw type (lead/ball), end fittings, limit/feedback, noise grade |
| Pumps & blowers | Flow, vacuum/pressure (to −98 kPa), voltage, noise, port geometry, fluid-contact & food-grade materials, high-temp (150 °C), Ex-proof |
| Controllers / drivers | Protocol (RS485·Modbus / CANopen / EtherCAT / PWM / analog), register map, I/O, firmware logic, form factor |
| Special development | New motor designed from load/speed/duty/envelope requirements |
We don't own the production line.
We own everything that tells it what to make.
The drawing, the tooling, and the pass/fail decision stay with MotorBank. Production runs in audited partner facilities under our management — which is exactly why your part stays consistent, lot after lot.
Engineered by us
Every custom product starts from our drawing. The design is engineered, versioned and owned by MotorBank.
Molds under our control
We build and control the molds and tooling. Dedicated tooling means your custom part can't be made for anyone else — and can't be discontinued behind your back.
Audited partner facilities
Production runs in audited partner facilities under our management. We don't own the line — we own everything that tells the line what to make.
Our pass/fail decision
Incoming and outgoing inspection against our drawing, every lot. The pass/fail decision is made by MotorBank, not the factory.
Send us your drawing. Get an engineering answer in 48 hours.
NDA on request · your supplier identity is never disclosed.